Thermal-Grip IP40D Concrete Pinner for Low-Mid Range PSI Masonry, up to 4″ Fasteners

Thermal-Grip IP40D Concrete Pinner for low-mid range PSI masonry for use with up to 4″ Fasteners

The IP40D is a concrete pinner tool designed to attach insulation to a concrete or masonry substrate.It is primarily designed for low-mid range PSI masonry applications and should be used when attaching insulation over CMU block.

Features

Designed to attach rigid insulation to masonry substrates

No pre-drilling necessary, just point and shoot

Rapidly attaches rigid insulation to concrete, masonry, and tilt up / precast walls

Anchor lengths available from 1″ to 4″

Large 2.25″ diameter washer head secures insulation

Includes

Each tool comes with plastic blow-molded case

Two Li-ion batteries

Battery Charger

Tool Lubricating Oil

Specifications:

Average Pin Pull Out Values	4000 PSI Concrete: 442.2 lbs., 5000 PSI Concrete: 624.7 lbs., 6000 PSI Concrete: 625.2 lbs., CMU Block: 424.9 lbs.
Shots per fuel cell	500-800 depending on temperature
Lithium Ion battery size	7.2V
Battery charging time	1 Hour
shots per charge	1,000
Power Rating	90J
Fuel Cell	Fuel cells not included – The Simpson Strong-Tie GFC34 fuel cells are recommended

Averages based on published PSI strength at cure time per concrete mfg specs. Please note these values are only the pins pulling out of concrete.
The insulation would likely rupture or, or break anchor before achieving these values.